International Journal on Magnetic Particle Imaging IJMPI
Vol. 11 No. 1 Suppl 1 (2025): Int J Mag Part Imag
https://doi.org/10.18416/IJMPI.2025.2503059

Proceedings Articles

Design and safety considerations of I/O modules

Main Article Content

Liana Mirzojan (1) Fraunhofer IMTE, Fraunhofer Research Institution for Individualized and Cell-Based Medical Engineering, Lübeck, Germany 2) Institute of Medical Engineering, University of Lübeck, Lübeck, Germany), Eric Aderhold (Fraunhofer IMTE, Fraunhofer Research Institution for Individualized and Cell-Based Medical Engineering, Lübeck, Germany), Jan-Philipp Scheel (1) Fraunhofer IMTE, Fraunhofer Research Institution for Individualized and Cell-Based Medical Engineering, Lübeck, Germany 2) Institute of Medical Engineering, University of Lübeck, Lübeck, Germany), Jonas Schumacher (Fraunhofer IMTE, Fraunhofer Research Institution for Individualized and Cell-Based Medical Engineering, Lübeck, Germany), Florian Sevecke (1) Fraunhofer IMTE, Fraunhofer Research Institution for Individualized and Cell-Based Medical Engineering, Lübeck, Germany 2) Institute of Medical Engineering, University of Lübeck, Lübeck, Germany), Mandy Ahlborg (Fraunhofer IMTE, Fraunhofer Research Institution for Individualized and Cell-Based Medical Engineering, Lübeck, Germany), Matthias Graeser (1) Fraunhofer IMTE, Fraunhofer Research Institution for Individualized and Cell-Based Medical Engineering, Lübeck, Germany 2) Chair of Measurement Technology, Universität Rostock, Rostock, Germany)

Copyright (c) 2025 Liana Mirzojan, Eric Aderhold, Jan-Philipp Scheel, Jonas Schumacher, Florian Sevecke, Mandy Ahlborg, Matthias Graeser

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

Abstract

In Magnetic Particle Imaging, numerous data inputs and outputs are required to receive and process signals
from the feedback and receive coils, and to control the output associated with the drive and selection field coils.
Previously used conventional input/output (I/O) boards have shown limitations in regard to the initial start-up
procedures, safety assurance and usability. In order to address these issues, a more sophisticated I=O-Unit
was designed, incorporating and expanding the functionality of twelve measurement cards. These cards are
housed within the I=O-Unit as shielded, interchangeable modules and built up as synchronised multi channel
I/O system.

Article Details

References

[1] J.-P. Scheel, J. Ackers, and M. Graeser. Influence of switched mode
power supplies in an arbitrary waveform magnetic particle spectroscope. IJMPI, 10(1), 2024.

Most read articles by the same author(s)

<< < 3 4 5 6 7 8